Yamaha CVP-709 CVP-709/705 Owners Manual - Page 103
Attach two front legs and a rear leg., Install the pedal box.
![]() |
View all Yamaha CVP-709 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
2 Attach two front legs and a rear leg. Refer to the diagram below to verify the orientation of the legs. Rear leg Front leg Front leg Install and tighten four screws on each leg, starting with one of the front legs. 6 x 40 mm fixing screws Insert the pedal cord plug into the pedal connector. Insert the plug into the connector so that the side with the arrow mark is facing forward (keyboard side). If the plug does not fit easily do not try to force it, but check the plug for correct orientation, and then reinsert it into the connector. Insert the pedal cord securely until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. Attach the cord holder on the unit as shown in the illustration below, then use the cord holder to affix the pedal cord. 3 Install the pedal box. Remove the twist tie and tape that affix the pedal cord to the upper portion of the pedal box. Tape 4 Raise the unit to the standing position. Use the front legs as support to raise the unit. CAUTION • Be careful not to pinch your fingers. • When you raise the unit, do not hold the key cover. . Twist tie Align the cord with the groove on the unit, and attach the pedal box using four screws. CVP-709 (Grand piano type) Assembly 6 x 20 mm fixing screws CVP-709/CVP-705 Owner's Manual 103
![](/manual_guide/products/yamaha-cvp709-cvp709705-owners-manual-421abdd/103.png)