Yamaha EL-500 Owner's Manual - Page 38

3 Press the Page buttons to select the various pages for the other Flute Voice functions. ATTACK Page PAGE 3 Flute Voices (Organ Sounds) - EL-700 only NOTE: "Mode" is common to both Upper and Lower Flute Voices. 1 23 1 Attack Footages Determines the level of each volume in the percussive portion of the voice. Footage settings are 4', 2-2/3' and 2'. 2 Attack Length Determines the duration of the attack sound. 3 Mode Determines which notes in a held group of notes are given an attack sound. • FIRST: Only the first note played will have attack; all other notes played while the first is held have no attack. • EACH: All notes played have an attack sound. VOLUME Page PAGE NOTE: No reverb can be obtained even though you raise the level here, unless you raise the total reverb level using the panel Reverb buttons (page 49). NOTE: If the Volume is set to 0, no sound will be produced. 123 45 1 Click Determines the volume of the key click sound. Click is independent of the Attack sound described above. 2 Response Determines the overall response speed of the sound. Lower settings make the keyboard response faster; higher settings result in a slower response, creating a pipe organ effect. 3 Tremolo Turns the Tremolo effect for the Flute Voice on or off. This is the primary on/off switch for the Tremolo/Chorus effect. After this has been set to ON, you can turn the effect on and off during your performance by using the TREMOLO (FAST) button in the DISPLAY SELECT section. (See the Tremolo section, page 56 for more information.) 4 Reverb Determines the amount of reverb applied to the Flute Voice voice. Range: 0-24 5 Volume Determines the overall volume of the Flute Voice voice. Range: 0-24 38