Yamaha MGP32X Owner's Manual - Page 17
FX RTN (effect return) FX TO FX BLEND knob - a
View all Yamaha MGP32X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Controls and Connectors FX RTN (effect return) section e TAP button and indicator This feature lets you set the delay time for FX2 by tapping on the button. This feature only works when the effect type for FX2 is set to ", DELAY" or ". SINGLE DELAY." To set the delay time, tap on the button at the appropriate interval. The average interval at which you tap the button will be calculated, and that value will be set for the delay time. Continue tapping as necessary until you get the timing right. The average interval will be set (the average of a, b, and c) a b c This section sets the effect returns (FX1 and FX2) on/off, and determines the level of the effect signal and to which bus the signal is sent. q AUX (PRE) knobs (1-4) These knobs adjust the level of the effect sent to the AUX1 to AUX4 buses. w FX TO FX BLEND knob Sends the signal from FX1 to FX2 and from FX2 to FX1. Rotate this knob from the center "OFF" position to the right to adjust the send level from FX1 to FX2, and to the left to adjust the send level from FX2 to FX1. Only the pre-fader signal can be sent. First tap Second tap Third tap Fourth tap The TAP indicator flashes in sync with the delay time when , DELAY or . SINGLE DELAY is selected. NOTE • Adjust the average interval within range of the variable delay time. • See page 44 for the range of the variable delay time. r ON switch Turn this switch on ( ) to enable the FX RTN (effect return). When the switch is turned on, the switch's lamp comes on. t SIG (Signal) indicator Lights when an effect signal is input into the channel. y Bus assign switches These switches determine the bus(es) to which the signal of the internal digital effects is sent. Press the switch in ( ) to output the signal to the corresponding buses. • Switches 1-2, 3-4: Assign to the GROUP1 to GROUP4 buses. • ST switch: Assigns to the STEREO L/R bus. u PFL (Pre-Fader Listen) switch and indicator When the PFL switch is turned on ( ), the indicator will light and the pre-FX (1, 2) RTN-fader signal is output to the MONITOR OUT and PHONES jacks for monitoring. i FX RTN (effect return) faders (1, 2) These adjust the level of the effect sent from the internal effect to the GROUP1 to GROUP4 buses, and STEREO L/R buses. MGP32X/MGP24X Owner's Manual 17