Yamaha MGP32X Owner's Manual - Page 49

Appendix Analog Input Characteristics Input Terminals MONO CH Input MGP32X: 1-24 MGP24X: 1-16 ST CH Input MGP32X: 25-32 MGP24X: 17-24 MONO CH INSERT Input MGP32X: 1-24 MGP24X: 1-16 ST CH INSERT Input L, R TALKBACK Input PAD GAIN TRIM Actual Load For Use With Impedance Nominal Sensitivity*1 Input level Nominal Connector Max. before clip -60 dB 0 -16 dB -34 dB 26 dB +10 dB 3 kΩ 50-600 Ω Mics 600 Ω Lines -80 dBu (0.078 mV) -60 dBu (0.775 mV) -40 dBu (7.75 mV) XLR-3-31 type*2 -36 dBu (12.3 mV) -16 dBu (123 mV) +4 dBu (1.23 V) Phone Jack*4 -54 dBu (1.55 mV) -34 dBu (15.5 mV) -14 dBu (155 mV) Phone Jack*3 -10 dBu (245 mV) +10 dBu (2.45 V) +30 dBu (24.5 V) -34 dB - +10 dB 10 kΩ 600 Ω Lines -54 dBu (1.55 mV) -34 dBu (15.5 mV) -14 dBu (155 mV) Phone Jack*4 -10 dBu (245 mV) +10 dBu (2.45 V) +30 dBu (24.5 V) RCA Pin Jack -- -- -- 10 kΩ 600 Ω Lines -20 dBu (77.5 mV) 0 dBu (0.775 V) +20 dBu (7.75 V) Phone Jack*5 10 kΩ 10 kΩ 600 Ω Lines 50-600 Ω Mics -20 dBu (77.5 mV) -66 dBu (0.389 mV) 0 dBu (0.775 V) -50 dBu (2.45 mV) +20 dBu (7.75 V) Phone Jack*5 -30 dBu (24.5 mV) XLR-3-31 type*6 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms. *1 Sensitivity is the lowest level that will produce an output of +4 dB (1.23 V), or the nominal output level when the unit is set to maximum level. (all faders and level controls are at maximum position.) *2 XLR-3-31 type connectors are balanced .(1=GND, 2=HOT, 3=COLD) *3 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND) *4 Phone Jacks are unbalanced. *5 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND) *6 XLR-3-31 type connectors is unbalanced. Analog Output Characteristics Output Terminals Actual Source Impedance For Use With Nominal Output Level Nominal Max. before clip STEREO OUT L, R 75 Ω 600 Ω Lines +4 dBu (1.23 V) +24 dBu (12.3 V) MONO OUT GROUP OUT 1-4 AUX SEND 1-6 MATRIX OUT 1-2 MONO CH INSERT OUT MGP32X: 1-24 MGP24X: 1-16 ST CH INSERT OUT L, R MONITOR OUT L, R PHONES OUT 75 Ω 150 Ω 75 Ω 150 Ω 75 Ω 75 Ω 150 Ω 150 Ω 600 Ω Lines 10 kΩ Lines 600 Ω Lines 10 kΩ Lines 10 kΩ Lines 10 kΩ Lines 10 kΩ Lines 40 Ω Phones +4 dBu (1.23 V) +4 dBu (1.23 V) +4 dBu (1.23 V) +4 dBu (1.23 V) 0 dBu (0.775 V) 0 dBu (0.775 V) +4 dBu (1.23 V) 3 mW +24 dBu (12.3 V) +20 dBu (7.75 V) +24 dBu (12.3 V) +20 dBu (7.75 V) +20 dBu (7.75 V) +20 dBu (7.75 V) +20 dBu (7.75 V) 75 mW 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms. *1 XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD) *2 Phone Jacks are impedance balanced. (Tip=HOT, Ring=COLD, Sleeve=GND) *3 Phone Jacks are unbalanced.(Tip=Out, Ring=In, Sleeve=GND) *4 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND) Connector XLR-3-32 type*1 Phone Jack*4 XLR-3-32 type*1 Phone Jack*2 XLR-3-32 type*1 Phone Jack*2 Phone Jack*3 Phone Jack*3 Phone Jack*2 Stereo Phone Jack MGP32X/MGP24X Owner's Manual 49