Yamaha QY700 Owner's Manual - Page 149

Job 04, Crescendo

Page 149 highlights

7. Song Jobs 5. Offset • This parameter adds a fixed value to each of the Rate-adjusted gate times. A setting of 0 produces no change. Positive values increase the gate time, while negative values decrease it. Original gate timing (Gate) 32 32 32 Offset = -20 48 48 (Gate) 12 12 12 Offset = +20 28 28 JOB 04 CRESCENDO (Gate) 52 52 52 68 68 0101 1101 -9999,...,+0000,...,+9999 • You use this job to apply a crescendo or decrescendo to the specified range of notes (pitches) in the specified segment of the designated track. The QY700 produces the effect by applying a slight velocity adjustment (offset) at the beginning of the segment, with the offset increasing gradually up until the end of the segment. 1. Track setting: TR • This parameter selects the sequence track to which adjustment is applied. 0101 1101 01,...,32 2. Segment and notes (M and Note=) • The two boxes at the top of the screen (to the right of the M) select the track segment over which the crescendo or diminuendo is created. The first box sets the measure and beat for the start point; the second box sets the end point. The Note boxes select the range of notes (pitches) to be targeted by the adjustment: notes with pitches outside this range are not affected. 0101 1101 Measure: beat Note range 001:1,...,999:8 C-2,...,G8 3. Range • You use the Range parameter to set the intensity of the crescendo. • The Range setting selects the value added to the velocities of notes at the final meter and beat of the segment. The QY700 gradually increases the amount added to (or subtracted from) the velocities within the segment, beginning with a "0" amount at the beginning of the segment, and ending with the full Range amount at the end of the segment. • Velocity cannot be less than 1 or higher than 127. Adjusted valves below 1 are raised to 1, adjusted values above 127 are set to 127. 148 Chapter 2. SONG MODE

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334

148
Chapter 2. SONG MODE
5. Offset
This parameter adds a fixed value to each of the Rate-ad-
justed gate times. A setting of 0 produces no change. Posi-
tive values increase the gate time, while negative values
decrease it.
0101
1101
-9999,...,+0000,...,+9999
7. Song Jobs
JOB 04
CRESCENDO
You use this job to apply a crescendo or decrescendo to the
specified range of notes (pitches) in the specified segment
of the designated track. The QY700 produces the effect by
applying a slight velocity adjustment (offset) at the begin-
ning of the segment, with the offset increasing gradually up
until the end of the segment.
1. Track setting:
TR
This parameter selects the sequence track to which adjust-
ment is applied.
0101
1101
01,...,32
2. Segment and notes (M and Note=)
The two boxes at the top of the screen (to the right of the M)
select the track segment over which the crescendo or di-
minuendo is created. The first box sets the measure and beat
for the start point; the second box sets the end point. The
Note boxes select the range of notes (pitches) to be targeted
by the adjustment: notes with pitches outside this range are
not affected.
0101
1101
Measure: beat
001:1,...,999:8
Note range
C-2,...,G8
3. Range
You use the Range parameter to set the intensity of the cre-
scendo.
The Range setting selects the value added to the velocities
of notes at the final meter and beat of the segment. The
QY700 gradually increases the amount added to (or sub-
tracted from) the velocities within the segment, beginning
with a “0” amount at the beginning of the segment, and
ending with the full Range amount at the end of the seg-
ment.
Velocity cannot be less than 1 or higher than 127. Adjusted
valves below 1 are raised to 1, adjusted values above 127
are set to 127.
Original gate timing
Offset = -20
Offset = +20
(Gate)
(Gate)
(Gate)
32
32
32
48
48
12
12
12
28
28
52
52
52
68
68