Yamaha QY700 Owner's Manual - Page 65

BASIC CONCEPTS the same "C" note 8. Enter notes. • Press microkeyboard to enter notes. • A line of a length corresponding to the length of the speci- fied note will appear, and the song position pointer will move to the right. • In this example, press the middle "D" microkeyboard (D3). Song position pointer Deleting a mistakenly-entered note • To delete the note that was entered immediately before, press 5 (BkDelete). The note that was entered will disappear, and the song position pointer will move back, allowing you to re-enter the note. • To delete any undesired note, move the cursor to the note that you wish to delete, and press 6 (Delete). All notes located at the same timing will be deleted. Using Jobs • In track 1, measures 3 - 10 are identical to measures 23 - 30. In such cases, you can use the Song job Copy Event for more efficient data entry. (1) Press s to stop Step Recording. (2) Press j to access the Job menu. (3) Use the data dial, n/y, the cursor keys, or the numeric keypad to select "11 Copy Event" and press e to access the Copy Event job. (4) Set the upper line to Song 01, TR=01, M003:1 - 010:4, the lower line to Song 01, TR=01, M 023 × 1, and press e. Note that was entered 9. Enter a tie. • The note to be entered next is connected to the following note by a tie. (1) Set the note value to a 16th note, and enter an "E" (E3). (2) Set the note value to an 8th note, and press s (TIE). The note length will be extended by an 8th note, and the song position pointer will move. s Repeat steps 6 through 9, and enter all the notes of track 1. 10. Press s to stop recording. • Press p to playback. Now let's playback. • Press the sequencer key p to playback the song. • Make sure that the performance of track 1 is correct. 64 Chapter 1