Yamaha RX-V1000 Owner's Manual - Page 41

INTRODUCTION PREPARATION BASIC OPERATION Depending on the item, press k / n to select a sub item. 2 LOW FRQ TEST TEST TONE OFF OUTPUT MAIN L/R FRQ 88Hz 4 Press -/+ repeatedly to change the setting of the item. 2 LOW FRQ TEST TEST TONE ON OUTPUT MAIN L/R FRQ 88Hz 5 Press k / n repeatedly until the current DSP program appears or simply press one of the DSP program group buttons to exit from the SET MENU. 10KEY DSP HALL 1 HALL 2 CHURCH JAZZ CLUB 1 2 3 4 ROCK ENTER- TV or CONCERT STADIUM TAINMENT SPORTS 5 6 7 8 MONO MOVIE 9 MOVIE MOVIE THEATER 1 THEATER 2 10 11 /DTS SUR. 12 0 +10 +100 SET MENU 1 SPEAKER SET (speaker mode settings) Use this feature to select suitable output modes for your speaker configuration. You must set the output mode when you use a subwoofer. Notes • When 96-kHz sampling digital signals are input to this unit, level adjustments in items 1B and 1E are possible, but those in items 1A, 1C, 1D and 1F are not affected. • When 6CH INPUT is selected as the input source, level adjustments in items 1A through 1F are not affected. s 1A CENTER SP (center speaker mode) By adding a center speaker to your speaker configuration, the unit can provide good dialog localization for many listeners and superior synchronization of sound and images. The OSD shows a large, small or no center speaker depending on how you set this item. Choices: LRG (large), SML (small), NONE Initial setting: LRG LRG Select this if you have a large center speaker. The entire range of the center channel signal is directed to the center speaker. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the settings of the SET MENU you adjusted will return to the factory settings. If so, adjust the items again. 1A CENTER SP LRG SML NONE SML Select this if you have a small center speaker. The lowfrequency signals (90 Hz and below) of the center channel are directed to the speakers selected with "1E LFE/BASS OUT". 1A CENTER SP LRG SML NONE ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 37