Yamaha RX-V1000 Owner's Manual - Page 73
Changing Parameter Settings, Resetting a Parameter to the Factory-set Value - factory reset
View all Yamaha RX-V1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
INTRODUCTION PREPARATION BASIC OPERATION Changing Parameter Settings You can enjoy good quality sound with the factory-set parameters. Although you do not have to change the initial settings, you can change some of the parameters to better suit the input source or your listening room. Adjustments should be made with the remote control. y • We recommended that you edit the parameter while using a video monitor. It is easier to see the video monitor than it is to see the front panel display. 3 10KEY DSP HALL 1 HALL 2 CHURCH JAZZ CLUB 1 2 3 4 ROCK CONCERT 5 STADIUM 6 ENTERTAINMENT 7 TV SPORTS 8 6.1/ES MONO MOVIE 9 MOVIE MOVIE THEATER 1 THEATER 2 10 11 /DTS SUR. 12 CHP/INDEX 0 +10 +100 + TV VOL - A/B/C/D/E PRESET + TV INPUT CH TV MUTE - DISC MUTE EFFECT + VOLUME - 2 ON SCREEN LEVEL 4 SLEEP TEST PARAMETER SET MENU 1 5 SOUND FIELD PROGRAM PARAMETER EDITING 4 Press k / n to select the parameter. 5 Press -/+ to change the parameter value. y • When you set the parameter to a value other than the factoryset value, an asterisk mark (*) appears by the parameter name on the video monitor. 6 Repeat steps 3 to 5 above as necessary to change other program parameters. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If so, edit the parameter value again. Resetting a Parameter to the Factory-set Value 1 Set PARAMETER/SET MENU to PARAMETER. PARAMETER SET MENU 2 Turn on the video monitor and press ON SCREEN repeatedly to select the full display mode. ON SCREEN 3 Select a DSP program you want to adjust. 10KEY DSP HALL 1 HALL 2 CHURCH JAZZ CLUB 1 2 3 4 ROCK CONCERT 5 STADIUM 6 ENTERTAINMENT 7 TV SPORTS 8 MONO MOVIE 9 MOVIE MOVIE THEATER 1 THEATER 2 10 11 /DTS SUR. 12 0 +10 +100 Program No. Program name (group) Cursor P05 ROCK CONCERT INIT.DLY LIVENESS REV.TIME REV.DELAY REV.LEVEL 15ms 5 1.6s 100ms 7% s To reset some of the parameters to the factory-set values Select the parameter you want to reset. Then press and hold - or + until the value temporarily stops at the factory-set value. The asterisk mark (*) by the parameter name disappears on the video monitor. s To reset all of the parameters to the factory-set values Use "9 PARAM. INI" on the SET MENU to reset all of the parameter values of all DSP programs within the selected group to the factory-set values (see page 42). This operation resets all of the parameter values of all DSP programs within that group to the factory-set values. Notes • The available parameters may be displayed on more than one OSD page for some of the programs. To scroll through pages, press k / n. • You cannot change parameter values when "15 MEMORY GUARD" on the SET MENU is set to ON. If you want to change the parameter values, set "15 MEMORY GUARD" to OFF (see page 44). Parameters Example of ROCK CONCERT ADDITIONAL INFORMATION ADDITIONAL INFORMATION APPENDIX English 69