Yamaha RX-V1000 Owner's Manual - Page 45
L/R BALANCE (balance of the left and right main speakers), 4 HP TONE CTRL (headphone tone control)
View all Yamaha RX-V1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
SET MENU INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION 3 L/R BALANCE (balance of the left and right main speakers) Use this feature to adjust the balance of the output level from the left and right main speakers. Control range: 10 steps for L/R Initial setting: 0 Press + to decrease the output level for the left main speaker. Press - for the right main speaker. 4 HP TONE CTRL (headphone tone control) Use this feature to adjust the level of the bass and treble when you use your headphones. Control range (dB): -6 to +3 Initial setting: 0 dB for both BASS and TRBL (treble) 5 CENTER GEQ (center graphic equalizer) Use this feature to adjust the built-in 5-band graphic equalizer so that the center speaker tonal quality matches that of the left and right main speakers. You can select the 100 Hz, 300 Hz, 1 kHz, 3 kHz, or 10 kHz frequencies. Control range (dB): -6 to +6 Initial setting: 0 dB for 5-band 1 Press n to select a higher frequency and k to select a lower frequency. 2 Press -/+ to adjust the level of that frequency. y • You can monitor the center speaker sound while adjusting this item by using the test tone. Press TEST before starting the foregoing procedure. "TEST DOLBY SUR." appears on the video monitor, and the test tone starts alternating among the speakers. Once you begin this procedure, the test tone remains at the center speaker and you can hear how the sound changes as you adjust the various frequency levels. To stop the test tone, press TEST (see pages 22 and 23). 6 INPUT RENAME Use this feature to change the name of the input which appears on the OSD or the front panel display. 1 Press an input selector button (or use INPUT l / h) to select the input you want to change the name of. 2 Press -/+ to place the _ (under-bar) under the space or the character you want to edit. 3 Press k / n to select the character you want to use and -/+ to move to the next one. • Press n to change the character in the following order, or press k to go in the reverse order. A to Z, a space, 0 to 9, a space, a to z, a space, #, *, +, and so on. • Follow the foregoing procedure to rename other inputs. Note • You can use up to 8 characters to rename the inputs. 4 Press + repeatedly to exit from INPUT RENAME. 7 I/O ASSIGNMENT Use this feature to designate the input for the COMPONENT jacks (A and B) and the DIGITAL INPUT/OUTPUT jacks (1 to 8 (or 9 for the China and general models only)) to any sources you want. s 7A [A] [B] (for the COMPONENT VIDEO jacks) Initial settings: [A] DVD [B] D-TV/LD s 7B (1) (2) (for the OPTICAL OUTPUT jacks) Initial settings: (1) MD/TAPE (2) CD-R s 7C (3) to (6) (for the OPTICAL INPUT jacks) Initial settings: (3) CD (4) CD-R (5) DVD (6) D-TV/LD s 7D (7) (8) (9 (China and general models only)) (for the COAXIAL INPUT jacks) Initial settings: (7) CD (8) CBL/SAT (9) LD RF Note • You cannot select an item more than once for the same type of jack. ADDITIONAL INFORMATION APPENDIX English 41