Yamaha RX-V1000 Owner's Manual - Page 59

INTRODUCTION PREPARATION BASIC OPERATION s Controlling a different component from the source component (input) you have selected 1 Repeat steps 1 and 2 of the procedure in "Setting the Manufacturer Code". 2 Press l / h to select a library (component category). TITLE 6CH INPUT SOURCE DISPLAY MENU SELECT SEARCH ENTER SOUND - CHAPTER + POWER REC / STOP PAUSE PLAY There are 13 libraries to set up a manufacturer code: L:TV, L:CAB (CABLE), L:DBS, L:SAT, L:VCR, L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP (TAPE), L:TUN (TUNER) and *L:AMP. 3 Repeat steps 3 and 4 of the procedure in "Setting the Manufacturer Code". About amplifier libraries (L:AMP) L:AMP has 4 codes: YPC, Zone2, DSP, and No. "YPC" or "Zone2" should be selected to operate this unit. "DSP" is for operating YAMAHA DSP amplifiers other than this unit. "No" is to clear this unit control area functions. Note • "YPC" is factory-set as the amplifier library. When you make up a second audio-video room with this unit's Zone 2 feature, you must set "Zone2" as the amplifier library in the remote control (see page 62 for details). V-AUX SYSTEM POWER STANDBY REMOTE CONTROL FEATURES Programming a New Remote Control Function (Learn Feature) If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the buttons are programmable independently for each source component area. Note • This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote control's functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.) 1 Set 10KEY/DSP to 10KEY. 10KEY DSP 2 Press an input selector button, A or B to select a source component. SYSTEM POWER STANDBY PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR 2/DVR DVD 3 Place this remote control and the other remote control about 50 to 100 mm (2 to 4 in.) apart on a flat surface so that their infrared transmitters are aimed at each other. TRANSMIT RE-NAME CLEAR LEARN MACRO TUNER MD/TAPE CD-R D-TV/LD CBL/SAT VCR 1 VCR 2/DVR DVD TITLE ENTER MACRO OFF ON PHONO CD 6CH INPUT about 50 to 100 mm (2 to 4 in.) ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 55