Yamaha RX V2700 MCXSP10 Manual - Page 135
Controlling Zone 2 or Zone 3, Using the internal amplifiers of this unit - owner s manual
UPC - 027108927077
View all Yamaha RX V2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
■ Using the internal amplifiers of this unit USING MULTI-ZONE CONFIGURATION IMPORTANT SAFETY NOTICE The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel. Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner's manual for correct usage. Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver. If you want to use one internal amplifier (SP1 or SP2) of this unit Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and select either "INT:[SP1]" or "INT:[SP2]" for "Zone2 Amplifier" or "Zone3 Amplifier" (see page 113). If you want to use two internal amplifiers (both SP1 and SP2) of this unit Connect the Zone 2 or Zone 3 speakers directly to the SP1 and SP2 speaker terminals and select "Both" for "Zone2 Amplifier" or "Zone3 Amplifier" (see page 113). Second room (Zone 2) R+ SP1 - PRESENCE - +L R+ SURROUND BACK/ - BI-AMP - +L SINGLE R SP2 L + - Third room (Zone 3) This unit Controlling Zone 2 or Zone 3 You can select the zone you want to control by using the control buttons on the front panel or on the remote control. ■ Selecting Zone 2 or Zone 3 Front panel operations 1 Press ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel to individually turn on or off Zone 2 or Zone 3. 2 Press ZONE CONTROLS on the front panel repeatedly to select the zone you want to control. ZONE CONTROLS Each time you press ZONE CONTROLS, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds. However, no indicator flashes when the main zone is selected. ZONE2 ZONE3 ZONE ON/OFF ZONE 2 ZONE 3 No indicator flashes when the main zone is selected. y Once MASTER ON/OFF on the front panel is pressed inward to the ON position, you can also press POWER and STANDBY on the remote control to turn on the main zone, Zone 2 and Zone 3. ZONE2 Controls the Zone 2 amplifier or tuner functions. ZONE3 Controls the Zone 3 amplifier or tuner functions. ADVANCED OPERATION 131 En