Yamaha RX V2700 MCXSP10 Manual - Page 22
Connecting to the SP2 speaker, terminals, Connecting the banana plug, except U.K., Europe
UPC - 027108927077
View all Yamaha RX V2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
CONNECTIONS 5 Hook the speaker terminal wrench onto the WRENCH HOLDER on the rear panel of this unit when not in use. ■ Connecting the banana plug (except U.K., Europe, Asia and Korea models) The banana plug is a single-pole electrical connector widely used to terminate speaker cables. Banana plug ■ Connecting to the SP2 speaker terminals Connect Zone 2 or Zone 3 speakers to these terminals (see page 130). 1 Tighten the knob using the supplied speaker terminal wrench. Speaker terminal wrench 1 Open the tab. Red: positive (+) Black: negative (-) 2 Insert one bare wire into the hole on the terminal. Red: positive (+) Black: negative (-) 2 Insert the banana plug connector into the end of the corresponding terminal. 3 Close the tab to secure the wire. y You can also use the banana plug with the SP2 speaker terminals. Open the tab and then insert one banana plug into the hole on the terminal. Do not close the tab after connecting the banana plug. 18 En