Yamaha RX V2700 MCXSP10 Manual - Page 145
ADDITIONAL, INFORMATION, Dolby Digital or DTS - problem
UPC - 027108927077
View all Yamaha RX V2700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
TROUBLESHOOTING Problem Cause Remedy No sound is heard from the surround back speakers. "Surround" in "Speaker Set" is set to "None" and "Surround Back" is automatically set to "None". Set "Surround" and "Surround Back" to a setting other than "None". "Surround Back" in "Speaker Set" is set to Set "Surround Back" to a setting other than "None". "None". Dolby Digital or DTS sources cannot be played. (Dolby Digital or DTS indicator in the front panel display does not light up.) The connected component is not set to output Dolby Digital or DTS digital signals. Audio input jack select is set to "ANALOG". Make an appropriate setting following the operating instructions for your component. Set Audio input jack select to "AUTO". A humming sound is Incorrect cable connections. heard. Connect the audio cables firmly. If the problem persists, the cables may be defective. No connection from the turntable to the GND terminal. Connect the grounding cable of your turntable to the GND terminal of this unit. The volume level is low while a record is being played. The record is being played on a turntable Connect your turntable to this unit through an MC- with an MC cartridge. head amplifier. The volume level cannot be increased, or the sound is distorted. The component connected to the AUDIO OUT (REC) jacks of this unit is turned off. Turn on the power of the component. The sound effect cannot be recorded. It is not possible to record the sound effect with a recording component. A source cannot be recorded by a digital recording component connected to the DIGITAL OUTPUT jack. The source component is not connected to the DIGITAL INPUT jacks of this unit. Some components cannot record Dolby Digital or DTS sources. Connect the source component to the DIGITAL INPUT jacks. A source cannot be recorded by an analog component connected to the AUDIO OUT (REC) jacks. The source component is not connected to Connect the source component to the analog AUDIO the analog AUDIO IN jacks of this unit. IN jacks. The sound field parameters and some other settings of this unit cannot be changed. "Memory Guard" in "Option" is set to "On". Set "Memory Guard" to "Off". See page 106 106 - 42 - 26 26 - 24, 26 26 114 ADDITIONAL INFORMATION 141 En