Zanussi ZCG551GNC Product Manaul - Page 19

To replace the glass panels obey the procedure in opposite sequence. Before you lower the trim attach the A trim part to the door. Refer to picture. Oven lamp Warning! There is a danger of electrical shock! Before you change the oven lamp: • Switch off the oven. • Remove the fuses in the fuse box or switch off the circuit breaker. Put a cloth on the bottom of the oven for protection of the oven light and glass cover. What to do if... Replacing the oven lamp 1. You can find the lamp glass cover at the back of the cavity. Turn the lamp glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the oven lamp with an applicable 300 °C heat-resistant oven lamp. Important! Use the same oven lamp type. 4. Install the glass cover. Warning! Refer to "Safety information" chapter. Problem The appliance does not operate. The appliance does not operate. The grill, burners, ovens and timer do not work. The grill, burners, ovens and timer do not work. The grill, burners, ovens and timer do not work. Only main oven does not work. There is no spark when lighting the gas. The flame is blow out immediately after ignition. Possible cause The fuse in the fuse box is released. The appliance is too hot. There is no electrical supply. There is no electrical supply. There is no gas supply. Time is not set. Burner cap and crown are placed uneven. Thermocouple is not heated sufficient. Remedy Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. Cool down the appliance for some hours Make sure that the unit is connected and the electrical supply is switched on. Examine the house electrical installation fuse. Examine the house gas supply, use other gas appliance (Central heating or gas fires). Set the time Make sure that the burner cap and crown are in correct positions. After lightning the flame, keep the knob pushed for approximately 5 seconds. www.zanussi.com 19