Zanussi ZCG551GNC Product Manaul - Page 7

For time change you must not set an automatic function (Duration or End ) at the same time. Preheating Set an oven to maximum temperature and run an empty oven for 45 minutes, to burn off any Hob - Daily use residue from the cavity surface. Accessories can become hotter than in normal use. During this period an odour can be emitted. This is normal. Make sure the room is well ventilated. Warning! Refer to "Safety information" chapter. Lighting the burners Warning! Be very careful when you use open fire in a kitchen environment. The manufacturer declines all responsibility in case of misuse of the flame. Always light the burner before you put cookware on it. 1. Turn the knob to the maximum position and push it down. When you push the knob, the spark generator activates automatically. 2. Keep the control knob pushed for approximately 5 seconds. This lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the crown and its cap are in the correct positions. 1 9 2 8 3 7 4 6 5 1 Burner cap 2 Burner crown 3 Ignition candle 4 Thermocouple 5 Hob 6 Slots 7 Burner body 8 Location peg 9 Hole Replacing burner parts 1. Carefully put the burner crown on the burner body. Do not use force. a) Make sure that the hole in the crown is above the ignition candle. b) Make sure that the location pegs are in the slots in the burner body. c) Let the crown fall freely onto the body. d) Make sure that you can move the crown a small distance from side to side. 2. Put the burner cap centrally on top of the crown (enamel side up). Move the cap from side to side and front to back to make sure that it is correctly installed. 3. Try to light the burner. If the burner does not ignite, adjust the crown and cap again. Warning! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. www.zanussi.com 7