Zanussi ZCG551GNC Product Manaul - Page 21

Installation, Minimal distances - gas cooker

Page 21 highlights

Installation Warning! Refer to "Safety information" chapter. Technical data Dimensions Height 894 - 912 mm Width 600 mm Depth 600 mm Top oven capacity 34 l Main oven capacity 79 l Location of the appliance You can fit your freestanding appliance with cabinets on one or both sides and in the corner. D A B C A EF C Dimension F mm less than 400 Levelling Use small feet on the bottom of appliance to set same level of cooker top surface with other surfaces The stability chain Caution! You must install the stability chain. If you do not install it the appliance can tilt. Before you install stability chain, adjust the appliance to the correct height. Measure down 180 mm from the appliance top surface, then measure right 30 mm (See picture). Mark the position of the wall and this gives anchor point for the stability chain. Minimal distances Dimension mm A 650 B 150 C 2 D 400 E 50 180 mm 30 mm Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover. Gas Category Gas Supply I2H G20 - 20 mbar www.zanussi.com 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

Installation
Warning!
Refer to "Safety information"
chapter.
Technical data
Dimensions
Height
894 - 912 mm
Width
600 mm
Depth
600 mm
Top oven capacity
34 l
Main oven capacity
79 l
Location of the appliance
You can fit your freestanding appliance with
cabinets on one or both sides and in the cor-
ner.
A
A
B
C
C
D
E
F
Minimal distances
Dimension
mm
A
650
B
150
C
2
D
400
E
50
Dimension
mm
F
less than 400
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
The stability chain
Caution!
You must install the stability
chain. If you do not install it the appliance
can tilt.
Before you install stability chain, adjust the
appliance to the correct height.
Measure down 180 mm from the appliance top
surface, then measure right 30 mm (See pic-
ture). Mark the position of the wall and this
gives anchor point for the stability chain.
30 mm
180 mm
Warning!
These instructions are only valid
in the countries whose symbols appear on
this booklet's cover.
Gas Category
I2H
Gas Supply
G20 - 20 mbar
21
www.zanussi.com