Zanussi ZCG551GNC Product Manaul - Page 23
Environment concerns
![]() |
View all Zanussi ZCG551GNC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
2. Examine the supply pressure by turning the Rapid burner and one other burner fully on, and lighting them. The pressure must be: a) 20 mbar for Natural Gas b) 29 mbar for LPG, butane only c) 37 mbar for LPG, propane only. 3. Turn the taps off and disconnect the pressure gauge. 4. Make sure that all burners work correctly. Checking the grill 1. Put in the grill pan containing the grid. 2. Light the grill burner by turning the grill con- trol knob to the symbol . 3. Release the knob when the burner comes on. Checking the hob burners 1. Lift the lid. 2. Put in the burner crowns and caps. Make sure that they are correctly seated. 3. Put in the pan supports. 4. Check each of the burners in turn by turning the burner control knob to the symbol . 5. Release the knob when the burners come on. Checking the lid shut-off device 1. Lift the lid. 2. Light one of the hob burners. 3. Close the lid. There should be no gas supply to the hob burners. The burner goes out. 4. Turn the burner off and lift the lid. The gas supply should be restored to the hob burners, when you turn the knob on. Environment concerns Checking the main oven 1. Turn the gas oven control knob to the sym- bol . 2. When the oven burner comes on, the gas at first flows to the oven burner slowly, at the FSD by-pass rate. 3. When the FSD heat sensor is heated sufficiently, it opens the FSD valve. The main gas stream flows to the burner. 4. After 1 minute make sure that the flame covers the full width of the burner and is stable. 5. Set the oven control knob to the maximum position and close the oven door. After about 10 minutes the flame size should decrease. 6. Turn the control knob off and check that the oven flames go out. Electrical installation The manufacturer is not responsible if you do not follow the safety precautions from the chapter "Safety information". This appliance is supplied with a main plug and a main cable. Connect the phases correctly, if you do not connect, spark generator will work all the time. MANUFACTURER: ELECTROLUX POLAND Sp.z o.o.. ul.Kazimierza Odnowiciela 28 58-100 Świdnica - POLAND The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the www.zanussi.com environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. 23
![](/manual_guide/products/zanussi-zcg551gnc-product-manaul-679f1a9/23.png)