1995 Chevrolet Corvette Owner's Manual - Page 106

4. Remove the four screws that attach the console door. 5. Remove the console door. NOTICE: When usingthe accessory plug: 0 Don't splice wires directly into the accessory plug wire. If done incorrectly, splicing might cause damage to your electrical system. 0 The maximum load of any electrical equipment should not exceed 10 amps. 0 Be sure to turn off any electrical equipment when not in use. Leaving electrical equipment on for extended periods can drain your battery. 0 Do not use this plug if the electrical equipment requires frequent connecting and disconnecting. This may cause excessive wear on the accessory plug and damage your electrical system. After you've installed theelectrical equipment, put the trim panel and console lidback in placeand install the screws. 6. Remove the trim plate by pulling up and back. 7. Disconnect the plug by pulling forward on the plastic locking tab and pull the plug into the console. The plug has three separate wires: 0 The orange wire connects to the battery. The pink wire connects to the ignition. Power is only available in RUN. 0 The black wire connects to the ground. 2-63