1995 Chevrolet Corvette Owner's Manual - Page 130

Be sure to reset the monitor when your oil is changed, even if the CHANGE OIL light didn't come on. If you don't reset the monitor, won't work correctly. Follow it these steps: Service Ride ControlLight If your vehicle is equipped with Selective Ride Control, this amber light should come on for a few seconds when you start your vehicle. 1. Turn the key to RUN, but don't start the engine. 2. Press ENG MET on the Trip Monitor. Then, within five seconds, press it again. 3. Witbin five seconds, press and hold GAUGES on the Trip'Monitor.The CHANGE OIL light should flash. 4. Hold the GAUGES button until the CHANGE OIL light stops flashing and goes out. This should take about ten seconds. When the light goes out, the monitor is reset. If the monitor doesn'treset, turn the ignition off, then try again. SERVICE RIDE CONTROL If the light stays on orcomes on while you're driving, there may be a problem with your Selective Ride Control system. You can still drive, but you should see your dealer soon. The Selective Ride Control system is designed to sense vehicle speed in the first minute after the vehicle is started. If the vehicle is not moved in that first minute, the system records a fault. The SERVICE RIDE CONTROL light comes on after three faults are recorded. If the light comes on for this reason, move your Corvette and the light should go out. 2-87