1995 Chevrolet Corvette Owner's Manual - Page 141

I 8. Slide both lock pillar brackets down and forward from the receiver brackets. You may need to liftthe hardtop slightly to remove the brackets. 9. Disconnect both wire connectorslocated behind the lock pillar brackets. These are the rear window defogger wires. 10. With one person on each side, gently lift the hardtop approximately 8 inches (200 mm) straight up. Remove the hardtop over the rear of the vehicle. 11. Install the HATCH (45) fuse to enable the storage compartment lid release button and center console release switch. You will need the fuse installed if you have to raise your convertible top. The fusethat enables these releases is not installed at the assembly plant and should be in your center console. See "Instrument Panel Fuse Block" in the Index for location of the fuse when installing it. 2-98