1995 Chevrolet Corvette Owner's Manual - Page 143

5. Move both seatbacks forward. Slide the lock pillar bracket intothe receiver bracket until the scribed line is even with the lower edge of the receiver bracket. 6. Connect the electrical connectorsand make sure they are inside the vehicle. 7. 11. Insert the lower bolt into the bottom flange of the lock pillar brackets and tighten. Install and tighten the remaining bolts into the lock pillar brackets. 12. Using the ratchet, tighten the rear corner bracket bolts. Do not over-tighten these bolts. 13. Slide the rear trim panel in place. Insert the two upper bolts intoboth receiver brackets. You may have to lift the hardtop slightly to install the lockpillar bracket. 8. If the hardtophasn't lowered into position, pull the release leverbehind the driver's seat under the storage compartment lid. tighten the rear cornerbracket 9. Secure but don't bolts using the ratchet. LO. Tighten the front bolts using the wrench. 14. Remove the HATCH (45) fuse. Store it in the center console while the convertible hardtop is in use. (This will prevent accidental unlatching of the storage compartment lid.) ! 2-100