2003 Ford Excursion Owner Guide 1st Printing (Spanish) - Page 345
2003 Ford Excursion Manual
Page 345 highlights
Driver Controls 4. Press and hold both trip computer controls. After approximately four seconds, the trip computer will enter zone setting E/M MODE mode. Zone setting mode is indicated when the display lights the RESET "ZONE" indicator. 5. Release both controls. Subsequent pressing of either control will increment the zone. Press the control repeatedly until the correct zone setting for your geographic location is displayed on the trip computer. 6. To exit the zone setting mode and save the displayed zone in memory, release both controls for greater than five seconds. Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Locate the trip computer located in the overhead console. 2. Start the vehicle. 3. Press and hold both trip computer controls. After approximately eight seconds, the trip computer will enter CAL mode. E/M MODE CAL mode is indicated when the display lights the "CAL" indicator. RESET 4. Release both controls. The display will return to normal, except that the CAL indicator will remain lit until the compass is successfully calibrated. 5. Slowly drive the vehicle in a circle (less than 5 km/h [3 mph]) until the CAL indicator turns off. It may take up to five circles to complete calibration. 6. The compass is now calibrated. 71