2003 Ford Excursion Owner Guide 1st Printing (Spanish) - Page 357

Locks and Security • the ignition is turned to the ON position, or • using the UNLOCK control on your remote entry transmitter. This feature is initially turned off, but may be turned on by following the instruction in the activation/deactivation procedure provided. Power door unlock disable feature - activation/deactivation 1. Turn the ignition key to ON, then press the UNLOCK button 3 times. 2. Turn the ignition key to OFF, then press the UNLOCK button 3 times. 3. Turn the ignition key to ON, within five seconds press the UNLOCK button 2 times then LOCK once. The user should receive 2 horn chirps to indicate the system has been disabled or 2 chirps followed by a honk to indicate the system has been enabled. Pressing the power door LOCK button two times again will turn the feature ON if it was previously OFF, or OFF if it was previously ON. Every two consecutive presses of the LOCK button after successfully entering the configuration mode will change the enable/disable condition of the feature. Turn ignition to OFF to exit programming. Sounding a panic alarm to activate the alarm. Press again or turn the ignition to ACC Press or ON to deactivate. Note: The panic alarm will only operate when the ignition is in the OFF position. Replacing the battery The remote entry transmitter uses one coin type three-volt lithium battery CR2032 or equivalent. The typical operating range for your remote entry transmitter is approximately 10 meters (33 feet). A decrease in the operating range could be caused by: • weather conditions, • nearby radio towers, 83