2003 Pontiac Montana Owner's Manual - Page 126
2003 Pontiac Montana Manual
Page 126 highlights
Resetting the Power Sliding Door The power sliding door may operate incorrectly or not at all because of the following conditions: 4. Remove fuse 29 from the underhood fuse block. Leave it out for 30 seconds. 5. Reinstall the fuse and wait 10 seconds. A low voltage or dead battery, disconnecting the battery, or 6. Turn the power sliding door override switch on. 7. Press either of the power door lock switches to open the power sliding door. 8. Open the door all of the way. if the instrument panel PWWHEATED SEAT PSD fuse or the underhood fuse 8,27 or 29 are removed or blown. See Fuses and Circuit Breakers on page 5-95 for more information about your fuse panel. 9. Wait five seconds and close the door by pressing either power door lock switch. 10. Wait five seconds and repeat Steps 7 through 9. If any of these conditions occur, the power sliding door will need to be reset. If your vehicle has the dual power sliding doors, both doors will have to be reset. To do this: 1. Check to be sure the power sliding door is unlocked and securely closed. 2. Turn the ignition key to OFF. 3. i f w,.l, iui.i.l ijuwei- s;iLlii-ly dlOi- o.".ei-i?ide S.vv/tC;-, o.m If the door does not rest in the fully open position after repeating Step 7, repeat Steps 7 through 9 again. If the door still does not operate correctly, see your dealer for service. 2-19