2003 Pontiac Montana Owner's Manual - Page 402

Storing the Spare Tire and Tools 1. Lay the tire near the rear of the vehicle with the valve stem down. 2. If the vehicle has aluminum wheels, remove the small center cap by tapping the back of the cap with the extension of the shaft. 3. Slide the cable retainer through the center of the wheel and start to raise the tire. Make sure the retainer is fully seated across the underside of the wheel. 4. When the tire is almost in the stored position, turn the tire so the valve is towards the rear of the vehicle. This will help when you check and maintain tire pressure in the spare. 5. Raise the tire fully against the underside of the vehicle. Continue turning the folding wrench until yuu ieei I I I V I ~ I ~ I i w u &As. ?lis i i - ~ d i ~ ~ &tilt: ii I iirai ~ compact spare tire is secure and the cable is tight. The spare tire hoist cannot be overtightened. PUSH & PULL 6. Make sure the tire is stored securely. Push, pull, and then try to rotate or turn the tire. If the tire moves, use the folding wrench to tighten the cable. Put back all tools as they were stored in the jack storage compartment and put the compartment cover back on. To put the cover back on, line up the tabs on the right of the cover with the slots in the cover opening. Push thn nn I ~ IY -1n-n n m rh mo n r le: b u ~ c l ;E pabc a- Au pua11 r l u v rvs lnI thn tnh 1I u 1 I lau 1 c n su thnt it tI I a t I t v n I ~ ; s ~ s in the groove. This secures the cover in place. 5-8 1