2003 Pontiac Montana Owner's Manual - Page 207
2003 Pontiac Montana Manual
Page 207 highlights
Directing the Airflow To direct the airflow to the rear-seating area, use the right knob located on the main climate-control panel. Select vent or bi-level mode to direct air to the rear of the vehicle through the overhead outlets. ^ These controls are overhead, on the control panel located behind the front seats. A rear-seat passenger can use these controls to personally adjust the temperature and the fan speed for the rear-seating area. The fan knob located on the switchbank must be turned to R (Rear) to allow the rear-seat passengers to use the controls located on the control panel in the rear-seating area. If this fan knob is not in R when the FAN or TEMP button is pressed, the rear control panel will show DISABLED. Select floor, defog or defrost mode to direct air to the rear of the vehicle through the floor outlets. Generally the upper outlets are used for air conditioning and the floor outlets are used for heating. Selecting the Fan Speed If the driver is adjusting the fan speed, use the following control: (Fan): Turn the fan knob on the rear fan control located below the main climate-control system on the switchbank to numeral 1, 2, or 3 to increase or decrease airflow to the rear-seating area. Turn the fan knob on the rear fan control to 0 to turn off the fan. l i a rear-seat passenger is adjusting the fan speed, use the following control: % FAN: Press the FAN button on the rear control panel. The display will show the current setting. Press the left and right arrow buttons to cycle through the available settings: OFF, LOW, MED and HIGH. 3-30