2003 Pontiac Montana Owner's Manual - Page 245
2003 Pontiac Montana Manual
Page 245 highlights
Set the volume at the desired level. Press this button to select MIN, MED or MAX. Each higher choice allows for more volume compensation at faster vehicle speeds. Then, as you drive, SCV automatically increases the volume, as necessary, to overcome noise at any speed. The volume level should always sound the same to you as you drive. If you don't want to use SCV, select OFF. SCAN : Press and hold one of the SCAN arrows for two seconds until SCAN appears on the display and you hear a beep. The radio will go to a station, play for a few seconds, then go on to the next station. Press one of the SCAN arrows again to stop scanning. To scan preset stations, press and hold one of the SCAN arrows for more than four seconds until PSCAN and the preset number appear on the display. You will hear a double beep. The radio will go to the first preset station stored on your pushbuttons, play for a few seconds, then go on to the next preset station. Press one of the SCAN arrows again to stop scanning presets. The radio will scan only to stations that are in the selected band and only to those with a strong signal. A v RCL (Recall): Push this knob to switch the display between the radio station frequency and the time. Pushing this knob with the ignition off will display the time. To change the default on the display, push the knob until you see the display you want, then hold the knob until the display flashes. The selected display will now be the default. Setting Preset Stations The six numbered pushbuttons let you return to your favorite stations. You can set up to 18 stations (six AM, six FMI and six FM2) by performing the following steps: 1. Turn the radio on. Finding a Station BAND: Press this button to switch between AM, FM, or FM2. The display will show your selection. TUNE: Turn this knob to choose radio stations. SEEK : Press the up or the down arrow to go to the next or to the previous station and stay there. The radio will seek only to stations that are in the selected band and only to those with a strong signal. A v 2. Press BAND to select AM, FMI or FM2. 3. Tune in the desired station. 4. Press EQ to select the equalization. 3-68