2008 Subaru Tribeca Owner's Manual - Page 104
2008 Subaru Tribeca Manual
Page 104 highlights
2-10 Keys and doors & Sounding a panic alarm To activate the alarm, press the "PANIC" button once. The horn will sound and the turn signal lights will flash. To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote transmitter is pressed, the alarm will be deactivated after approximately 30 seconds. signal. You can also use the same steps to restore the function. 1. Sit in the driver's seat and shut all doors and the rear gate. 2. Hold down the UNLOCK side of the power door locking switch. 3. While holding down the "UNLOCK" side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after Step 2. 4. Open and close the driver's door once within 10 seconds after step 3. 5. The turn signal lights flash 3 times to indicate completion of the setting. You may have the above settings done by your SUBARU dealer. swallow them. When the transmitter battery begins to get weak, transmitter range will begin to decrease. Replace the battery as soon as possible. To replace the battery: & Replacing the battery CAUTION . Do not let dust, oil or water get on or in the transmitter when replacing the battery. . Be careful not to damage the printed circuit board in the transmitter when replacing the battery. . Be careful not to allow children to touch the battery and any removed parts; children could 1. Remove the screw on the key head. & Selecting audible signal operation Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Do the following to deactivate the audible