2008 Subaru Tribeca Owner's Manual - Page 299

In case of emergency 9-3 the "Temporary spare tire" section in this chapter for instructions and precautions. & Removing the spare tire 1. Take the wheel nut wrench and extension out of the tool bag. Refer to the "Maintenance tools" section in this chapter. temporary spare tire is on the ground with enough cable slack to allow you to pull it out from under the vehicle. CAUTION . Be sure to remove (not simply keep it open) the subfloor storage lid before turning the wheel nut wrench, otherwise the lid may be damaged. . Do not put your fingers into the center hole of the temporary spare tire while you pulling it out, because they might be pinched in between the wheel and the retainer. 5. Fit the extension onto the hex-headed hoist shaft end. 2. Remove the subfloor storage lid in the cargo area. 3. Take out the jack. 4. Locate the hex-headed hoist shaft end inside the hole. 6. Fit the wheel nut wrench onto the extension. 7. Turn the hoist shaft end counterclockwise with the wheel nut wrench until the 8. Tilt the retainer at the end of the cable - CONTINUED -