2008 Subaru Tribeca Owner's Manual - Page 282

8-14 Driving tips ! Installing carrying attachments on the crossbars When installing any carrying attachment such as a bike carrier, ski carrier, kayak carrier, cargo basket, etc. on the crossbars, follow the manufacturer's instructions and make sure that the attachment is securely fixed to the crossbars. Use only attachments designed specifically for the crossbars. A set of the crossbars is designed to carry loads (cargo and attachment) of not more than 150 lbs (68 kg). Before operating the vehicle, make sure that the cargo is properly secured on the attachment. ! To remove the crossbar 2. Carefully raise the crossbar from roof rails. ! To install the crossbar Front crossbar: Front crossbar has 150 LBS Load Label on left-hand side. NOTE Remember that the vehicle's center of gravity is altered with the weight of the load on the roof, thus affecting the driving characteristics. Drive carefully. Avoid rapid starts, hard cornering and abrupt stops. Crosswind effects will be increased. ! Removal and installation of the crossbars The crossbars can be removed when you do not use the roof to carry cargo. 1. Loosen and remove the T-30 torx® head screw from the top of each crossbar end support. Loosen the lower clamps. 1) T-25 torx® head screw 1. Make sure that the T-25 torx® head screw on the back of each crossbar end support is tightened correctly. 2. Before placing the crossbar on the roof rails, make sure that the T-30 torx® head screw is removed from the top of each crossbar end support.