2011 Subaru Tribeca Owner's Manual - Page 114

Keys and doors 2-13 different. Programming transmitter codes into system: Key tag remote keyless entry system, it is necessary to program the transmitter's code (identification number) into the system. A tag showing the code is affixed to the key unit, and another is affixed to the circuit board inside the transmitter. If there is no tag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure. 1. Firmly close the doors and the rear gate. 2. Open the driver's door, sit on the driver's seat, and close the door. 3. Perform the following steps within 45 seconds. 1) 2) LOCK ON (2) Insert the key into the ignition switch, then turn it from the "LOCK" position to the "ON" position 10 times within 15 seconds. NOTE . When you complete step (2), an electronic tone will sound once, a buzzer will continue to sound and the interior light will continue to flash until the transmitter codes are completely registered. . If you do not perform steps (1) and (2) within 45 seconds, an error will occur. Neither an electronic tone nor the buzzer will sound, and the interior lamp will not flash. In this event, per- CONTINUED - Transmitter circuit board (1) Open and close the driver's door once. To register a new transmitter with the