2011 Subaru Tribeca Owner's Manual - Page 237
2011 Subaru Tribeca Manual
Page 237 highlights
6-20 Interior equipment trol System and your garage door opener should activate when the HomeLink® button is pressed. memory of all three buttons. 3. Hold the end of the entrance gate's/ garage door opener's hand-held transmitter between 1 and 3 inches (25 and 76 mm) away from the HomeLink® buttons on the driver's sun visor, keeping the indicator light in view. opener by pressing the programmed HomeLink® button. & Programming for entrance gates and garage door openers in Canada 1. Unplug the motor of the entrance gate or garage door opener from the outlet. & Programming other devices To program other devices such as door locks, home lighting and security systems, contact HomeLink at www.homelink.com or call 1-800-355-3515. & Operating the HomeLink® Wireless Control System Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which its buttons are programmed. To activate a device, simply press the appropriate button. The indicator light illuminates, indicating that the signal is being transmitted. 4. P r e s s a n d h o l d t h e d e s i r e d HomeLink® button. 5. Press and release ("cycle") the handheld transmitter button every 2 seconds until step 6 is complete. 6. When the indicator light flashes slowly and then rapidly after several seconds, release both buttons. 7. Plug the motor of the entrance gate/ garage door opener to the outlet. 8. Test your entrance gate/garage door & Reprogramming a single HomeLink® button 1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter of the device for which you wish to program the button at 1 to 3 inches (25 to 76 mm) away from the HomeLink® button surface. 2. Press and hold the two outside buttons until the HomeLink® indicator light begins to flash (after 20 seconds). Release both buttons. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the