2011 Subaru Tribeca Owner's Manual - Page 120

Keys and doors 2-19 mode. To exit valet mode, change the setting of your vehicle's alarm system for activation mode. Refer to "Activating and deactivating the alarm system" F2-16. 1. Turn the ignition switch to the "ON" position. & Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. ! To enter the passive mode If you wish to program the passive arming mode, have it done by your SUBARU dealer. ! Arming the system 1) 2) LOCK ON 4. Before closing the doors, lock all doors with the inside door lock levers. 5. Close the doors. The system will automatically arm after 1 minute. In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door locking switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected. ! Disarming the system To disarm the system, briefly press the " " button on the transmitter. CAUTION In passive mode, the system will automatically activate the alarm but WILL NOT automatically lock the doors. In order to lock the doors you must either lock them as indicated in step 4 below or with the key once they have been closed. Failure to lock the doors manually will result in a higher security risk. 2. Turn the ignition switch from "ON" to "LOCK" position and remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. - CONTINUED -