2011 Subaru Tribeca Owner's Manual - Page 340
2011 Subaru Tribeca Manual
Page 340 highlights
Maintenance and service 11-9 8. Clean the rubber seal seating area of the bottom of engine and install the oil filter by hand turning. Be careful not to twist or damage the seal. 9. Tighten the oil filter by the amount indicated in the following table after the seal makes contact with the bottom of engine. Oil filter color Black Part number 15208AA031 Amount of rotation 3/4 rotation Oil capacity (guideline): 6.7 US qt (6.3 liters, 5.5 Imp qt) CAUTION . Never over tighten the oil filter because that can result in an oil leak. . Thoroughly wipe off any engine oil that has spilled over the exhaust pipe and/or under-cover. If left unremoved, the oil could catch fire. 10. Reinstall the cover under the oil filter. 11. Pour engine oil through the filler neck. The oil quantity indicated above is only a guideline. The necessary quantity of oil depends on the quantity of oil that has been drained. The quantity of drained oil differs slightly depending on the temperature of the oil and the time the oil is left flowing out. After refilling the engine with oil, therefore, you must use the level gauge to confirm that the level is correct. 12. Start the engine and make sure that no oil leaks appear around the filter's rubber seal and drain plug. 13. Run the engine until it reaches the normal operating temperature. Then stop the engine and wait a few minutes to allow the oil drain back. Check the oil level again and if necessary, add more engine oil. Oil grade: ILSAC GF-4 or GF-5, which can be identified with the ILSAC certification mark (Starburst mark) or API classification SN or SM with the words "ENERGY CONSERVING" These recommended oil grades can be identified by looking for either or both of the following marks displayed on the oil container. & Recommended grade and viscosity CAUTION Use only engine oil with the recommended grade and viscosity. ILSAC Certification Mark (Starburst Mark) - CONTINUED -