2011 Subaru Tribeca Owner's Manual - Page 118

Keys and doors 2-17 & If you have accidentally triggered the alarm system ! To stop the alarm Do any of the following operations. . Press any button on the remote transmitter. . Turn the ignition switch to the "ON" position. once and the indicator lights will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the indicator lights will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance. If any of the doors or the rear gate is not fully closed, an electronic chirp sounds five times, the turn signal lights flash five times to alert you that the doors or the rear gate are not properly closed. When you close the door, the system will automatically arm and doors will automatically lock. ! To arm the system using power door locking switches 1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors and the rear gate but leave only the driver's door or the front passenger's door open. 6. Briefly press the " " button (for less than 2 seconds). All doors and the rear gate will lock, an electronic chirp will sound once, the turn signal lights will flash - CONTINUED - & Arming the system ! To arm the system using remote transmitter 1. Close all windows and the moonroof. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close all doors and the rear gate. : Press to Arm the system. : Press to Disarm the system.