2007 Suzuki Reno Owner's Manual - Page 184

SERVICE AND APPEARANCE CARE Removing the Spare Tire and Tools 4) Remove the compact spare tire. See "Compact Spare Tire" in this section for more information. 5) Remove the jack, jack handle and the wheel wrench. The jack is located in the cargo area. Turn the jack retainer, located on the right side of the jack, counterclockwise to release it. The jack handle and the wheel wrench are located inside the foam tray. Removing the Flat Tire and Installing the Spare Tire 1) If your vehicle is equipped with wheel covers, loosen the 4 plastic caps by hand with the aid of the wheel wrench and remove the wheel cover. 2) Then use the wheel wrench to loosen all the wheel nuts. Don't remove them yet. A. B. C. D. Jack Wrench Jack Handle Screwdriver 3) Near each wheel well is a notch in the frame which the jack head fits in. Position the jack and raise the jack head until it fits firmly into the notch in the vehicle's frame nearest the flat tire. Put the compact spare tire near you. The compartment spare tire and tools you'll need are located in the trunk. WARNING Getting under a vehicle when it is jacked up is dangerous. If the vehicle slips off the jack you could be badly injured or killed. Never get under a vehicle when it is supported only by a jack. WARNING Only use the jack for lifting this car during an emergency tire change. 1) Remove the trim cover from the floor of the cargo area by pulling up on the tab. 2) Remove the foam tray that contains the tools. 3) Turn the retainer on the compact spare tire counterclockwise and remove the retainer. 5-40