2007 Suzuki XL7 Owner's Manual - Page 111
2007 Suzuki XL7 Manual
Page 111 highlights
INSTRUMENT PANEL RELEARN REMOTE KEY This display allows you to match the Remote Keyless Entry (RKE) transmitter to your vehicle. To match a RKE transmitter to your vehicle, do the following: 1) Make sure the vehicle is in PARK (P). 2) Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays. 3) Press the set/reset button. The message REMOTE KEY LEARNING ACTIVE will display. 4) Press and hold the lock and unlock buttons on the first transmitter at the same time for about 15 seconds. A chime will sound indicating that the transmitter is matched. 5) To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of four transmitters matched to it. 6) To exit the programming mode, you must cycle the key to LOCK. Blank Display This display shows no information. PERSONALIZATION This display allows you to personalize the feature settings on your vehicle. Refer to "DIC Vehicle Personalization" in this section for more information. DIC Warnings and Messages Messages are displayed on the DIC to notify the driver that the status of the vehicle has changed and that some action may be needed by the driver to correct the condition. Multiple messages may appear one after another. Some messages may not require immediate action, but you can press the set/reset button to acknowledge that you received the messages and to clear them from the display. Pressing any of the DIC buttons also acknowledge and clear any messages. Some messages cannot be cleared from the DIC display because they are more urgent. These messages require action before they can be cleared. You should take any messages that appear on the display seriously and remember that clearing the messages will only make the messages disappear, not correct the problem. The following are the possible messages that can be displayed and some information about them. ALL WHEEL DRIVE OFF If your vehicle has the All-Wheel Drive (AWD) system, this message displays along with the All-Wheel Drive Disabled light when the rear drive system is overheating. This message turns off when the rear drive system cools down. If the warning message stays on for a while, you need to reset the warning message. To reset the warning message, turn the ignition off and then back on again. If the message stays on, see your dealer right away. Refer to "All-Wheel Drive (AWD) System" in "Your Driving, the Road, and Your Vehicle" in the "Driving Your Vehicle" section and "AllWheel Drive Disabled Light" in this section for more information. BATTERY SAVER ACTIVE This message displays when the charging system detects that the battery is being drained. You may notice that the vehicle attempts to reduce the drain for you by turning off accessories, such as interior fans, rear defogger, and heated seats. Turn off all accessories. If the vehicle is not running, start and run the engine for at least 10 minutes to allow the battery to recharge. If the engine is running and the condition persists, see your dealer immediately. BUCKLE PASSENGER SEATBELT This message reminds you to buckle the passenger's safety belt. Refer to "Passenger Sensing System" in "Airbag System" in the "Seats and Restraint Systems" section. This message displays and a chime sounds when the ignition is on, the driver's safety belt is buckled, the passenger's safety belt is unbuckled with the passenger airbag enabled, and the vehicle is in motion. You should have the passenger buckle their safety belt. This reminder will be repeated if the ignition is on, the vehicle is in motion, the driver is buckled and the passenger is still unbuckled, and the passenger airbag is 3-30