Brother International CS-8072 Users Manual - English - Page 26

CONTENTS BEFORE USE SEWING ATTACHING THE OPTIONAL WALKING FOOT This foot is very useful for sewing materials such as vinyl cloth, synthetic leather, thin leather, etc. These materials are difficult to feed when sewing but this foot can prevent such materials from crumpling, slipping or sticking to presser foot thanks to even feeding of upper and lower materials. 1 2 3 • You can use walking foot for sewing STRAIGHT STITCH ( · ) and ZIGZAG STITCH ( ). • Reverse stitches can not be sewn with the walking foot. Note You can not use this foot for sewing other patterns. 5 1. Push the "NEEDLE POSITION" button to raise the needle, and then turn off the power. 2. Raise the presser foot lever and remove the presser foot. 3. Use the included disc-shaped screwdriver to loosen the screw of the presser foot holder, and remove the presser foot holder. 4. Set the operation lever of the walking foot so that the fork sur- rounds the needle clamp screw, and set the walking foot shank 5 on the presser foot shaft. 6 1 1 Needle clamp screw 2 Operating lever 3 Walking foot shank 2 3 5. Lower the presser foot lever, insert the presser foot holder screw, and tighten the screw securely with the disc-shaped screwdriver. CAUTION 5 • Use the disc-shaped screwdriver to tighten the 6 screw securely. If the screw is loose, the needle may strike the presser foot and cause injury. • Be sure to turn the balance wheel toward the front of the machine to check that the needle does not strike the presser foot. If the needle strikes the presser foot, injury may result. CAUTION When sewing with the walking foot, sew at medium to low speeds. UTILITY STITCHES MAINTENANCE SEWING CHART PATTERNS (PROGRAMMED IN MACHINE) 23