Brother International Innov-is VM5200 Operation Manual - Page 28

LCD SCREEN Using the Machine Setting Mode Key Press to change the default machine settings (needle stop position, embroidery speed, opening display, etc.). To display the different settings screens, press for "Sewing settings", for "General settings" or for "Embroidery settings". Memo • Press or next to the page numbers, to display a different settings screen. Sewing settings a f i g j b k c d h e l m l l n a Select whether to use the sewing speed controller to determine the zigzag width (see page S-39). b Make adjustments to character or decorative stitch patterns (see page S-82). c Adjust the presser foot height. (Select the height of the presser foot when the presser foot is raised.) d Adjust the presser foot pressure. (The higher the number, the greater the pressure will be. Set the pressure at "3" for normal sewing.) (see page S-17) If the dual feed foot is installed and its roller is lowered, the pressure setting is fixed at "2" and cannot be changed. e Fine tune the feed of the dual feed foot (see page B-67). f Select whether "1-01 Straight stitch (Left)" or "1-03 Straight stitch (Middle)" is the utility stitch that is automatically selected when the machine is turned on. (see page S-21) g Select whether "Utility Stitch" or "Quilt Stitch" displayed first on the stitch selection screen when the "Sewing" is selected. h You can activate this setting after connecting the optional multi-function foot controller. (These settings are not operable unless the optional multi-function foot controller is attached to the machine.) Controller Main foot controller Heel switch Side pedal Functions that can be specified Start/Stop Select any of the following: Thread Cutting, Needle Position Up/Down, Single Stitch, Reverse Stitch (Reinforcement Stitch), Presser Foot Up/Down, No setting i Change the height of the presser foot when sewing is stopped when the pivot setting is selected (see page S-15). j Change the height of the presser foot when the machine is set to free motion sewing mode (see page S-40). k When set to "ON", the thickness of the fabric is automatically detected by an internal sensor while sewing. This enables the fabric to be fed smoothly (see pages S-8 and S-17). l Pressing the "Start/Stop" button or depressing the foot controller automatically lowers the presser foot (if it is raised) before starting sewing. When releasing the pedal of the foot controller or pressing the "Start/Stop" button to stop sewing, the presser foot will be automatically raised. m Pressing the "Thread Cutter" button automatically lowers the presser foot before cutting the thread. The presser foot will be raised after the thread is cut. n Press to save the current settings screen image to USB media (see page B-33) B-26