Brother International Innov-is VM5200 Operation Manual - Page 63

■ Checking the Needle Drop Point With the Embroidery Foot "W+" with LED Pointer Before beginning to embroider when using the embroidery foot "W+" with LED pointer, carefully read the procedures described in the "Embroidery" and "Embroidery Edit" chapters. a After press the embroidery frame is attached, in the embroidery screen.  The LED pointer indicates the needle drop point. Memo • When the LED pointer is turned on, the presser foot height is automatically adjusted according to the fabric thickness. • If is pressed again, the fabric thickness is remeasured and the presser foot is set to the optimum height. * The LED pointer turns off automatically by lowering the presser foot or returning to the previous page. Note • With thick elastic fabric, the position will be misaligned only at raised parts in the fabric. In this case, manually adjust the position according to the thickness of the fabric. • With fabric that has a very uneven surface such as quilting, the position is not correctly aligned. In this case, the pointer indication should be used only as a reference. BEFORE EMBROIDERING ■ Adjusting the LED Pointer Adjust the LED pointer if it indicates a point different than the actual needle drop point. B Before adjusting the LED pointer, mark the actual needle drop point on the fabric to be embroidered, and then hoop the fabric and attach the embroidery 1 frame. Getting Ready Note • As a default, some keys mentioned in the following procedures appear in light gray and are not available. To enable the keys for specifying the settings, attach embroidery foot "W+" with LED pointer to the machine. The keys are enabled after the embroidery foot is detected. a Press .  The settings screen appears. b Press .  The Embroidery settings screen appears. Memo • When using the "Embroidery" or "Embroidery Edit", touch to directly access the Embroidery settings screen. c Display screen. page 10 of the Embroidery settings Basic operations B-61