Brother International Innov-is VM5200 Operation Manual - Page 303

ERROR MESSAGES Marks Error Messages Preventive maintenance is recommended. Cause/Solution This message is displayed when the machine needs to be maintained. (see page A-19) Raise the buttonhole lever. Remove Dual Feed module from the machine. Remove Embroidery foot with LED pointer from the machine. Retrieving the pattern. Wait a moment. This message is displayed when the buttonhole lever is down, a stitch other than a buttonhole is selected, and the "Start/Stop" button or the "Reverse Stitch" button is pushed. This message appears when you try to start embroidering with the optional dual feed foot attached to the machine. Remove the dual feed foot before entering the embroidery mode. (see page B-67) This message appears when you try to start sewing utility/decorative stitch or character pattern using the optional embroidery foot with the LED pointer attached to the machine. Remove the embroidery foot with the LED pointer before entering the sewing mode. (see page B-60) This message is displayed when the machine is retrieving a previously saved pattern while in "Embroidery Edit" mode. Set the clock. This message appears when the time/date is not set. Set time/date. (see page B-20) The bobbin thread is almost empty. This message is displayed when the bobbin thread is running out. The bobbin winder safety device has activated. Is the thread This message is displayed when the bobbin is being wound, tangled? and the motor locks because the thread is tangled, etc. The carriage of the embroidery unit will move. Keep your hands etc. away from the carriage. This message appears before embroidery unit moves. The pockets are full. Delete a pattern. This message is displayed when the memory is full and a pattern must be deleted. The safety device has been activated. Is the thread tangled? Is This message is displayed when the motor locks due to the needle bent? tangled thread or for other reasons related to thread delivery. The shutoff support mode has been activated. Turn off the machine. The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller. The upper thread may not be threaded correctly. Thread the upper thread from the beginning. This message appears when the machine is in the shutoff support mode. Turn off the machine once to start the machine again. (see page B-30) This message is displayed when the "Start/Stop" button is pushed to sew Utility stitches or Character/Decorative stitches while the foot controller is connected. (This message does not appear when embroidering). This message is displayed when it seems that the upper thread has not been threaded correctly. The USB media was changed. Do not change the USB media This message is displayed when you attempt to select a while it is being read. pattern after the USB media in which the pattern is saved has been changed. There is no needle plate cover. Attach a needle plate cover. This message is displayed when the needle plate cover is not attached. This file cannot be used. This message appears if the file format is incompatible with this machine. Check the list of compatible file formats. (see page S-94) This file exceeds the data capacity and cannot be used. Use a This message is displayed when the file size exceeds the data suitable size file. capacity of the machine. Confirm the file size and format. (see page S-95) This key cannot be used at this time. This message is displayed when you press in the screen other than the Utility Stitch, or press in the screen other than the Utility Stitch or Character/Decorative Stitch. This key does not operate when the needle is down. Raise the This message is displayed when a key on the LCD display is needle and press the key again. touched while the needle is in the down position. This pattern cannot be sewn with this mode. This message is displayed when the selected stitch is not available for the specific function. Maintenance and Troubleshooting A 2 Appendix A-35