Brother International Innov-is VM5200 Operation Manual - Page 44

LOWER THREADING a Turn the main top cover. power to ON and open the b Align the groove in the bobbin with the spring on the bobbin winder shaft, and set the bobbin on the shaft. f Pass the thread through the thread guide. a Groove in the bobbin b Spring on the shaft c Pivot the spool pin so that it angles upward. Set the thread spool on the spool pin so that the thread unwinds from the front of the spool. a Thread guide g Pass the thread around the pre-tension disk making sure that the thread is under the pre-tension disk. a Spool pin b Spool cap c Thread spool d Spool felt d Push the spool cap onto the spool pin as far as possible, then return the spool pin to its original position. e While holding the pull the thread up thread with both hands, from under the thread guide plate. a Thread guide b Pre-tension disk h Follow steps g through B-41. through k on page B-40 ■ Untangling Thread from Beneath the Bobbin Winder Seat If the bobbin winding starts when the thread is not passed through the pre-tension disk correctly, the thread may become tangled beneath the bobbin winder seat. Wind off the thread according to the following procedure. a Thread b Bobbin winder seat a Thread guide plate CAUTION • Do not remove the bobbin winder seat even if the thread becomes tangled under the bobbin winder seat. It may result in injuries. B-42