Brother International IntelliFax-2600 Service Manual - Page 62
Low-voltage Power Supply PCB
View all Brother International IntelliFax-2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
1.13 Low-voltage Power Supply PCB (1) Remove the screw from the low-voltage power supply PCB. (2) Slightly lift up the low-voltage power supply PCB and disconnect it from the main PCB. (3) Disconnect the heater harness (of the blue and brown wires) from the low-voltage power supply PCB. Reassembling Notes • Be sure to route the heater harness through the three wire guides as illustrated above. IV - 30
IV
- 30
1.13
Low-voltage Power Supply PCB
(1)
Remove the screw from the low-voltage power supply PCB.
(2)
Slightly lift up the low-voltage power supply PCB and disconnect it from the main PCB.
(3)
Disconnect the heater harness (of the blue and brown wires) from the low-voltage power supply
PCB.
±
Reassembling Notes
•
Be sure to route the heater harness through the three wire guides as illustrated above.