Brother International PQ1600S Operation Manual - Page 13
Changing Needles
View all Brother International PQ1600S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Changing Needles CAUTION • Please make sure the power to the machine is turned off before carrying out the following operations. There is a chance of injury if the machine accidentally starts running during this operation. • Only use recommended sewing machine needles. Use of any other needle may break the needle, possibly resulting in injury. (page 18) Changing the Needle 1 Turn the sewing machine off. Raise needle to highest position using handwheel, and lower the presser foot. 2 Loosen screw with screwdriver, and remove needle. 3 Hold the needle with the flat side to the right, and insert the needle as far as it will go. Make sure needle is securely set in the needle chamber by screwing in tightly. Changing the Feed Pin 1 Set the feed dog to the "velvet" position. (See page 10.) 2 Remove needle (page 11), presser foot and needle plate (page 26). 3 Lower presser foot and turn handwheel until feed pin is in its highest position. 4 Insert small screwdriver (included) as shown in diagram. 5 While holding spring with fingertip, lower the feed pin changer onto the feed pin tip to pick it up. ✽ If the needle is not adequately inserted or the screw is loose, this may break the needle or cause a breakdown and the needle threader will not work. ✽ Check needles on a flat surface to make sure they are not bent. The needle should lay parallel to a surface. Flat surface Lay needle on a flat surface (such as the needle plate or a plate of glass). 6 Attach new feed pin to feed pin changer, lower and attach while holding spring with fingertip. 7 Remove screwdriver. 8 Re-attach needle plate, needle and presser foot. 11