Brother International PQ1600S Operation Manual - Page 19
Using the Needle Threader, Using the Spool Net
View all Brother International PQ1600S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
CAUTION Be sure to turn off the power before using the needle threader. There is a risk of injury if you accidentally step on the foot controller. Using the Needle Threader ✽ The needle threader can be used with machine needles #11 through #16. When using #9 needles or thinner, manually thread the needle. 2 Needle Threader 1 1 132 1 Make sure that the thread take-up lever is positioned as shown in the diagram and the needle is raised to it's highest position. 2 Holding the thread in your left hand, pull out about 20 cm (approx. 8 inches) (1), and then lower the presser foot lever (2). 7 Carefully pull the loop to the right to thread the needle. 3 Fully lower the needle threader (1), and then fully swing it to the back. 4 Pass the thread between the hook fingers (1) completely, then pass the thread around the right side of the pin (2). The hook (3) catches the thread. 5 Pass the thread through the thread trimmer from back to front to cut it. 6 Raise the presser foot lever, and then return the needle threader to its original position. The hook passes the thread through the eye of the needle. ● The needle threader cannot be used with the thread-needle combinations illustrated in the chart shown below. Transparent nylon thread can be used regardless of the chart, providing the needle used is a #14 or #16. Needle (HLX5) #11 #14 #16 Thread #20 #30 #20 #30 #20 Using the Spool Net 4 1 3 2 If using transparent nylon thread, metallic thread, or other strong thread, place the included spool net over the spool before using. If the spool net is too long, fold it once to match it to the spool size before placing it over the spool. 1 Spool net 2 Thread spool 3 Spool pin 4 Spool cap 17