Brother International PT-9500PC Quick Setup Guide - English and Spanish - Page 20

Before use ■ Connecting to a USB port Follow the following procedures to connect the PT-9500PC to the USB port of a personal computer running Windows® 98/98 SE/Me/ 2000 Pro/XP using the "Basic setup" (→ P.28) or to the USB port of a Macintosh. Note ● The USB interface cable is connected to a personal computer running Windows while the software is being installed and is connected to a Macintosh after the software has been installed. Do not connect the PT-9500PC to a personal computer until instructed to do so. Note ● When making a USB connection through a hub, a proper connection may not be possible due to the type of hub used. If this occurs, connect the PT-9500PC to a personal computer directly with the USB interface cable. ● The PT-9500PC cannot be connected to the USB port of a personal computer running Windows® 95/NT 4.0. In this case, the PT-9500PC must be connected to the serial port. Prepare the included USB interface 1 cable. Insert the plug on the end of the USB 2 interface cable into the USB port on the back of the PT-9500PC. Insert the plug on the end of the USB 3 interface cable into the USB port on the personal computer. • The location of the USB port varies according to the personal computer. For details, refer to the instruction manual for the personal computer. Note ● To use the PT-9500PC, the software must be installed on the personal computer. Proceed to "Installing the software" (→ P.25). Connect to PT-9500PC USB port. Connect to personal computer USB port. 19