Home » Brother International Manuals » Printers » Brother International HL-4150CDN » Manual Viewer

Brother International HL-4150CDN Network Users Manual - English - Page 78

Brother machine cannot print over the network.

UPC - 012502624998

View all Brother International HL-4150CDN manuals

Add to My Manuals
Save this manual to your list of manuals

Page 78 highlights

Troubleshooting Brother machine is not found on the network during the printer driver installation. (continued) Question Is there a wireless computer, Bluetooth supported device, microwave oven or digital cordless phone near the Brother machine or the WLAN access point/router? Interface Solution wireless Move all the devices away from Brother machine or WLAN access point/router. Brother machine cannot print over the network. Brother machine is not found on the network even after the successful installation. Question Interface Solution Are you using security software? wired/ See I'm using security software. on page 75. wireless Is your Brother machine wired/  Confirm the IP address and the Subnet Mask assigned with an available wireless IP address? Verify that both the IP addresses and Subnet Masks of your computer and the Brother machine are correct and located on the same network. For more information on how to verify the IP address and the Subnet Mask, ask the network administrator or visit the Brother Solutions Center 8 at http://solutions.brother.com/.  (Windows®) Confirm the IP address and the Subnet Mask using the Network Connection Repair Tool. Use the Network Connection Repair Tool to fix the Brother machine's network settings. It will assign the correct IP address and the Subnet Mask. To use the Network Connection Repair Tool, ask the network administrator for the details and then follow the steps below: Note • (Windows® 2000 Professional/XP/XP Professional x64 Edition/Windows Vista®/Windows® 7) You must log on with Administrator rights. • Make sure that the Brother machine is turned on and is network-connected to your computer. 73

Section	Page
NETWORKUSER’S GUIDE	1
Table of Contents	3
1 Introduction	6
Network features	6
Other Network features	7
Security	7
Secure Function Lock 2.0	7
Store Print Log to Network	7
2 Changing your machine’s network settings	8
How to change your machine’s network settings (IP address, Subnet mask and Gateway)	8
Using the control panel	8
Using the BRAdmin Light utility	8
Installing BRAdmin Light	8
Setting the IP address, Subnet Mask and Gateway using BRAdmin Light	9
Other Management Utilities	11
Web Based Management (web browser)	11
BRAdmin Professional 3 utility (Windows®)	11
Web BRAdmin (Windows®)	12
BRPrint Auditor (Windows®)	12
3 Configuring your machine for a wireless network (For HL-4570CDW(T))	13
Overview	13
Step by step chart for wireless network configuration	14
For Infrastructure mode	14
For Ad-hoc mode	15
Confirm your network environment	16
Connected to a computer with a WLAN access point/router in the network (Infrastructure mode)	16
Connected to a wireless capable computer without a WLAN access point/router in the network (Ad-hoc mode)	16
Confirm your wireless network setup method	17
Configuration using WPS or AOSS™ from the control panel menu to configure your machine for a wireless network (Automatic Wireless mode) (Infrastructure mode only) (Recommended)	17
Configuration using the machine’s control panel Setup Wizard to configure your machine for a wireless network	17
Configuration using the Brother installer application on the CD-ROM to configure your machine for a wireless network	18
Configuration using the Automatic Wireless mode	18
Configuration temporarily using a USB or network cable	19
Configuration using the PIN Method of Wi-Fi Protected Setup to configure your machine for a wireless network (Infrastructure mode only)	20
Configuring your machine for a wireless network (For Infrastructure mode and Ad-hoc mode)	21
Using WPS or AOSS™ from the control panel menu to configure your machine for a wireless network (Automatic Wireless mode)	21
Using the Setup Wizard from the control panel	21
Configuring your machine when the SSID is not broadcast	22
Configuring your machine for an enterprise wireless network	25
Using the Brother installer application on the CD-ROM to configure your machine for a wireless network	28
Using the PIN Method of Wi-Fi Protected Setup	29
4 Wireless configuration using the Brother installer application (For HL-4570CDW(T))	31
Before configuring the wireless settings	31
Configure the wireless settings	31
5 Control panel setup	36
Network menu	36
TCP/IP	36
Boot Method	36
IP Address	37
Subnet Mask	37
Gateway	37
IP Boot Tries	37
APIPA	37
IPv6	37
Ethernet (wired network only)	38
Status (For HL-4140CN and HL-4150CDN)/Wired Status (For HL-4570CDW(T))	38
Setup Wizard (wireless network only)	38
WPS or AOSS™ (wireless network only)	38
WPS w/PIN Code (wireless network only)	38
WLAN Status (wireless network only)	38
Status	38
Signal	38
Channel	39
Speed	39
SSID	39
Comm.Mode	39
MAC Address	39
Set to Default (For HL-4570CDW(T))	39
Wired Enable (For HL-4570CDW(T))	39
WLAN Enable (For HL-4570CDW(T))	39
Reset the network settings to the factory default	40
Printing the Network Configuration List	40
Printing the WLAN report (For HL-4570CDW(T))	41
Function table and default factory settings	42
HL-4140CN and HL-4150CDN	42
HL-4570CDW(T)	43
6 Web Based Management	45
Overview	45
How to configure the machine settings using Web Based Management (web browser)	45
Secure Function Lock 2.0	47
How to configure the Secure Function Lock 2.0 settings using Web Based Management (web browser)	47
Basic configuration	47
Restricting PC print by PC user login name	48
Setting up public mode	48
Other features	48
Synchronize with SNTP server	49
Store Print Log to Network	51
How to configure the Store Print Log to Network settings using Web Based Management (web browser)	51
Error Detection Setting	53
Understanding Error Messages	54
Using Store Print Log to Network with Secure Function Lock 2.0	55
7 Security features	56
Overview	56
Managing your network machine securely using SSL/TLS	57
Secure Management using Web Based Management (web browser)	57
Printing documents securely using SSL/TLS	59
Sending or Receiving an E-mail securely	60
Configuration using Web Based Management (web browser)	60
Sending an E-mail with user authentication	60
Sending or Receiving an E-mail securely using SSL/TLS	61
Using IEEE 802.1x authentication	62
IEEE 802.1x authentication configuration using Web Based Management (web browser)	62
Secure Management using BRAdmin Professional 3 (Windows®)	64
To use the BRAdmin Professional 3 utility securely, you need to follow the points below	64
Using Certificates for device security	65
Configure certificate using Web Based Management	66
Creating and installing a certificate	67
Step by step chart for creating and installing a certificate	67
How to create and install a self-signed certificate	67
How to install the self-signed certificate on your computer	67
How to create a CSR	72
How to install the certificate to your machine	73
Import and export the certificate and private key	73
How to import the self-signed certificate, the certificate issued by a CA, and the private key	73
How to export the self-signed certificate, the certificate issued by a CA, and the private key	74
Managing multiple certificates	74
Import and export a CA certificate	75
How to import a CA certificate and private key	75
How to export a CA certificate and private key	75
8 Troubleshooting	76
Overview	76
Identifying your problem	76
Go to the page for your solution from the lists below	76
Appendix A	82
Supported protocols and security features	82