Brother International LS-2125i Users Manual - English - Page 15

While holding the end of the thread, gently f press the foot controller to wind the thread Cut the thread, slide the bobbin winder shaft j to the left and remove the bobbin. around the bobbin a few times. Then stop the machine. Memo ● When the sewing machine is started or the 1 handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction. ● The needle bar does not move when you slide the bobbin winding shaft to the right. Trim the excess thread above the bobbin. g CAUTION ● Winding the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury. CAUTION ● Make sure you follow the instructions carefully. If you do not cut the thread completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break. Press the foot controller to start. h 1 2 a Wound evenly b Wound poorly When the bobbin seems full and begins i spinning slowly, take your foot off the foot controller. 13