Brother International LS-2125i Users Manual - English - Page 16

KNOWING YOUR SEWING MACHINE Lower threading Install the bobbin wound with thread. Open the shuttle cover behind the flat bed b attachment at the front of the machine. CAUTION ● Winding the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury. 1 2 a Wound evenly b Wound poorly ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the enclosed bobbin or bobbins of the same type (part code: SA156, SFB: XA5539-151). Actual size 11.5 mm (7/16 inches) This model Other models CAUTION ● Make sure you turn the power off while threading the machine. If you accidentally step on the foot controller and the machine starts to sew, you could be injured. Raise the needle to its highest position by turning a the handwheel toward you (counterclockwise) and raise the presser foot lever. a Flat bed attachment b Shuttle cover Remove the bobbin case by pulling its latch c toward you and pulling it out from the shuttle race. a Bobbin case latch Unwind about 10 cm (4 inches) of thread d from a full bobbin, and then insert the bobbin into the bobbin case. • Only use bobbins that were designed to be used with this machine. CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. 14