Brother International LS-2125i Users Manual - English - Page 17
Make sure that the bobbin case is properly - how to thread a
UPC - 012502615293
View all Brother International LS-2125i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Pull the trailing thread through the slot, down e and to the left, as shown below, until it enters the delivery eye under the tension spring. a Tension spring Hold the bobbin case by the latch, fully insert f the bobbin case into the shuttle race, and then release the latch. • Make sure the bobbin case finger fits into the notch at the top of the shuttle race. a Bobbin case finger b Notch Close the shuttle cover. g CAUTION ● Make sure that the bobbin case is properly placed back into the machine. If it is incorrectly installed, it will fall out from the shuttle when the machine starts to sew. 1 15
15
1
e
Pull the trailing thread through the slot, down
and to the left, as shown below, until it enters
the delivery eye under the tension spring.
a
Tension spring
f
Hold the bobbin case by the latch, fully insert
the bobbin case into the shuttle race, and then
release the latch.
•
Make sure the bobbin case finger fits into the
notch at the top of the shuttle race.
a
Bobbin case finger
b
Notch
g
Close the shuttle cover.
●
Make sure that the bobbin case is properly
placed back into the machine. If it is incorrectly
installed, it will fall out from the shuttle when the
machine starts to sew.
CAUTION